DIY Quadcopter Flights Frames

quadcopter

I’ve gotten a few quadcopter flights beneath my belt and have had a risk to experiment with constructing special forms of diy frames.

That is my first best quadcopter, which i mentioned building here and right here:

From the start i had a few doubts about the sturdiness of this body, because it simply felt cheap and shoddy. Despite the greater strong landing tools i made out of aluminum and lots of superglue on all the joints, it nevertheless wasn’t very strong. So it wasn’t a total marvel when on considered one of my very first flights, on a barely out of manipulate however no longer extraordinarily difficult landing on grass one of the palms broke and i was left with this:

Not one of the electronic components had been damaged, and i’d been searching forward to making my very own diy frame so i wasn’t too disenchanted. I did want to get lower back within the air as soon as possible, so i went to lowe’s and purchased a few components that i notion might make a first rate frame. I were given an 8 foot duration of half of″ rectangular wood, and an 8″ via 10″ piece of acrylic. I made some wood hands that could increase past my propellers in case of every other hard landing, and i used the hobbyking body’s middle plate as a template for wherein to drill holes. After I connected all of the identical additives and aluminum touchdown gear, and ended up with my second quadcopter, which i dubbed the unpleasant duckling for apparent motives.

I think acrylic may be a amazing cloth for building quadcopter frames, however thicker portions are a must. The sheets they have got at lowe’s and home depot are very skinny and brittle to begin with and drilling a bunch of holes in them can’t be precise for the structural integrity. On another no longer-too-difficult grass touchdown a few harm become performed to the acrylic sheet that served as the imperative component of my body.

My next attempt changed into to use some 1/8″ thick wooden as the middle plate for my frame. Again i used the hobbyking frame as a template for the hole placement and re-used the hands from the ugly duckling. I cut the aluminum pieces of my landing tools in half of and used one piece on each of the four palms to present it a much broader base. Behold the spruce goose.

The spruce goose virtually flew quite nicely, but i were given a bit carried away and crashed right into a fence. The skinny wooden break up right along the grain.

They aren’t quite, but the properly component about all of these diy quadcopter frames is that there are a lot of ways you could construct one in which the parts only value round $10 or so and are available regionally. If each part of it breaks i’m able to go get replacements right away, without anticipating spare elements to deliver from a website. Additionally, while you’re constructing your personal you may re-use parts for more than one frames, improve upon your designs quick primarily based on what works and what doesn’t, and make changes relying on what you’re trying to do with a particular quadcopter.